[You must be registered and logged in to see this link.]
Hi friends, I hope you are doing fine, Today I will teach you about GPS Library for Proteus. A step by step Guide about the installation and usage of GPS Library for Proteus. I tried to make it simple and easy for better understanding.
In order to start working with the GPS Library for Proteus, you need to Download it. You can download it from the link given below.
Download GPS Library for Proteus ISIS
Now, Copy and Paste these files in to your Libraries folder (On a location where Proteus is installed)
If there is no error, you will get this:
[You must be registered and logged in to see this link.]
It has two pins altogether which are TX and RX.
Double tap the GPS module and its properties will popup
[You must be registered and logged in to see this link.]
It was all about GPS Library for Proteus. For any kind of help, Comment Below.
Hi friends, I hope you are doing fine, Today I will teach you about GPS Library for Proteus. A step by step Guide about the installation and usage of GPS Library for Proteus. I tried to make it simple and easy for better understanding.
In order to start working with the GPS Library for Proteus, you need to Download it. You can download it from the link given below.
Download GPS Library for Proteus ISIS
- After the completion of download, Unzip the file and you will find these 3 files
- LIB
- IDX
- HEX
Now, Copy and Paste these files in to your Libraries folder (On a location where Proteus is installed)
Note:
For Proteus 7 Professional,
C:\Program Files (x86)\Labcenter Electronics\Proteus 7 Professional\LIBRARY
For Proteus 8 Professional,
C:\ProgramData\Labcenter Electronics\Proteus 8 Professional\Data\LIBRARY
- After copying these files, Execute Proteus Software, If you are already running it, then close it and execute again.
- After that, Go to Components List and search GPS Module and Put it into the Workspace.
If there is no error, you will get this:
[You must be registered and logged in to see this link.]
It has two pins altogether which are TX and RX.
Double tap the GPS module and its properties will popup
[You must be registered and logged in to see this link.]
- All you have to do now is to paste the file GpsTEP.hex into Program Files.
- This GpsTEP.HEX record is fundamental for this model because it adds the GPS Functionality in the Model.
- After Placing the GpsTEP.hex file into the Programs , Your GPS module is up and ready to be fit in the circuit.
- In order to check the working of GPS Module, we will add Serial Monitor in it.
- Outline a little circuit as appeared in underneath figure:
[You must be registered and logged in to see this link.]
After Drawing the circuit, Execute the Simulation , if there is no error, you will get the following results.
[You must be registered and logged in to see this link.]
It was all about GPS Library for Proteus. For any kind of help, Comment Below.
Sat Apr 29, 2017 10:50 am by ubedullah
» Group hackers
Sat Apr 15, 2017 2:37 pm by Group Hackers
» Hacker Needed
Sat Apr 15, 2017 3:57 am by Group Hackers
» Hacker Needed
Sat Apr 15, 2017 1:45 am by Group Hackers
» Hacker Needed
Thu Apr 13, 2017 11:10 pm by Group Hackers
» Hacker Needed
Tue Apr 11, 2017 2:07 pm by Group Hackers
» Hacker Needed
Tue Apr 11, 2017 2:21 am by Group Hackers
» Hacker Needed
Tue Apr 11, 2017 2:06 am by Group Hackers
» Hacker Needed
Tue Apr 11, 2017 1:35 am by Group Hackers